FM25Q08
The FM25Q08 is a 8M-bit (1024K-byte) Serial Flash memory, with advanced write protection mechanisms. The FM25Q08 supports the standard Serial Peripheral Interface (SPI), Dual/Quad I/O as well as 2-clock instruction cycle Quad Peripheral Interface (QPI). They are ideal for code shadowing to RAM, executing code directly from Dual/Quad SPI (XIP) and storing voice, text and data.
The FM25Q08 can be programmed 1 to 256 bytes at a time, using the Page Program instruction. It is designed to allow either single Sector/Block at a time or full chip erase operation. The FM25Q08 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector or block.
Features
8Mbit of Flash memory
– 256 uniform sectors with 4K-byte each
– 16 uniform blocks with 64K-byte each or
– 32 uniform blocks with 32K-byte each
– 256 bytes per programmable page
Wide Operation Range
– 2.7V~3.6V single voltage supply
– Industrial temperature range
Serial Interface
– Standard SPI: CLK, CS#, DI, DO, WP#
– Dual SPI: CLK, CS#, DQ0, DQ1, WP#
– Quad SPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3
– QPI: CLK, CS#, DQ0, DQ1, DQ2, DQ3
– Continuous READ mode support
– Program/Erase Suspend and Resume support
– Allow true XIP (execute in place) operation
High Performance
– Max FAST_READ clock frequency: 104MHz
– Dual I/O Data transfer up to 208Mbits/s
– Quad I/O Data transfer up to 416Mbits/s
– Typical page program time: 1.5ms
– Typical sector erase time: 90ms
– Typical block erase time: 500ms
– Typical chip erase time: 8s
Low Power Consumption
– Typical standby current: 1μA
