BCT0104
This two-bit non-inverting translator is a bidirectional voltage-level translator and can be used to establish digital switching compatibility between mixed-voltage systems. It uses two separate configurable power-supply rails, with the A ports supporting operating voltages from 1.65V to 5.5V while it tracks the VCCA supply, and the B ports supporting operating voltages from 2.3V to 5.5V while it tracks the VCCB supply. This allows the support of both lower and higher logic signal levels while providing bidirectional translation capabilities between any of the 1.8V, 2.5V, 3.3V, and 5V voltage nodes.
When the output-enable (OE) input is low, all I/Os are placed in the high-impedance state, which significantly reduces the power-supply quiescent current consumption. OE has an internal pull-down current source, as long as VCCA is powered.
To ensure the high-impedance state during power up or power down, OE should be tied to GND through a pull-down resistor; the minimum value of the resistor is determined by the current-sourcing capability of the driver.
FEATURES
No Direction-Control Signal Needed
Data Rates
24Mbps (Push-Pull)
2Mbps (Open-Drain)
1.65V to 5.5V on A Ports and 2.3V to 5.5V on B Ports (VCCA ≤ VCCB)
VCC Isolation: If Either VCC is at GND, Both Ports are in the High-Impedance State
No Power-Supply Sequencing Required, Either VCCA or VCCB can be Ramped First
IOFF: Supports Partial-Power-Down Mode Operation
Available in QFN3.5x3.5-14L, TQFN3x3-16L, FO-12L package.
APPLICATIONS
I2C BUS
Portable POS Systems
Smart Card Readers
Cell-Phones
GPS
Portable Communication Devices
